Search results

Ask somebody to 3d print you a chainring type design that you put on each side and bolt together. The discs are compressed by the motor, you could maybe use metal instead. One bolt goes through the top of the down tube and seat stay, one goes under the down tube Just an idea don't know if it...

If I was doing this I would file the dropouts sides (sometimes this is not needed( and the depth An ebike axle is 12mm high plus the height of the tab washer plus a clearance height. You want the top of the tab on the washer to be sitting below the top of the dropout If the axle starts to...

https://www.selfcad.com/blog/6-best-3d-print-design-software https://www.xometry.com/resources/3d-printing/petg-vs-pla-3d-printing/#:~:text=PETG%20has%20these%20advantages%20over,reducing%20the%20risk%20of%20fracture.

Where are you based? I am looking to get rid of a hardly used 26" front wheel kit in Glasgow. The battery might need recelled though as it has not been charged regularly.

I would take the chain off, give it a good clean , oil it and store inside house in a lockable tupperware container.

https://ebiketips.road.cc/content/news/never-tackle-an-e-bike-battery-fire-yourself-warns-fire-brigade-after-another-blaze

A lot of people wear headphones as I am they don't hear you anyway

https://ebiketips.road.cc/content/news/intra-drive-seeks-crowdfunding-for-new-e-bike-mid-drive-with-8-speed-gearbox-4821

I think they have screws in them that tighten against the cable, I would loctite as well.

Are you toei g the brake blocks in? The back of the brake block need to be out further than the front. When the brakes are pressed against the rim at speed the block will become level due to the braking forces. Undo the bolt, put a small of card onto the back of the brake block, press against...

Buy a different colour quick link, for example grey chain, gold quick link. This gives you a starting / finishing point when oiling the chain, makes the quick link easier to see and cheaper than a gold tooth.

When did you last change the wheel bearings?

The max pressure of my tyres is 65psi, I run them at 55psi, 10psi below max.

Interesting idea https://ebiketips.road.cc/content/news/driven-seeks-crowdfunding-for-fully-enclosed-orbit-drive-e-bike-system-4771

https://ebiketips.road.cc/content/news/california-e-bike-licence-law-in-the-pipeline-4697

I have an ebike and a non ebike, sometimes it's nice to ride a lighter bike.

This is the adapter I used to fit my battery...