where to buy a 36v 250w geared moter wheel

[footpump]

trying to find a rear hub moter wheel to replace my bafang 8 fun 36v 250w moter wheel only 26"

but can only seem to find kits which seem to be throttle only

anyone in uk do moter wheels? as shipping from china will be costly

 

[Deleted member 4366]

What type of motor wheel do you need?
Power, size, cassette/freewheel, sensored/sensorless, weight, width, speed and voltage are all important characteristics.

 

[footpump]

need a 36v 250watt rear hub 26" moter wheel 7 speed freewheel 135mm

revs I would think at the lower end (201) bafang 8 fun wheel is from kudos mtb

 

[Woosh]

check the motor lead: 3-pin, 6-pin or 9-pin plug?

 

[Deleted member 4366]

need a 36v 250watt rear hub 26" moter wheel 7 speed freewheel 135mm

revs I would think at the lower end (201) bafang 8 fun wheel is from kudos mtb

Some of the Kudos ones are sensorless. Be careful!

 

[footpump]

thanks woosh the original moter lead is a six pin and had bog standard unbranded 14 amp controller, led handlebar unit with 3 levels of pas.

I have a kt led 890 handlebar unit I could use, buy a new controller ? if I can source a moter wheel.

I find the 350w yosepower rear hub as fitted , uses quite a lot of battery and range is not as good as I would like

 

[Woosh]

you need similar motor with 6-pin plug.
The trouble is, some motor has 1 magnet, some have 6 for the speed sensor. There is no way of knowing until you connect up the motor.
What's wrong with the old motor? may be worth repairing.

 

[footpump]

thanks all the moter works, what I haven't kept was the pas sensor,

also I have not got the 6 pin lead from moter to controller (think that must have been bined in error)
I have the newer kt type left hand pas sensor?

don't see any of the very thin wires on kudos controller

 

[Woosh]

I have not got the 6 pin lead from moter to controller (think that must have been bined in error)

your old motor is sensorless with internal speed sensor.

I have the newer kt type left hand pas sensor?

you can replace the broken pedal sensor with the KT left side sensor.