I need solar panel charger for my battery

Gh0stxSinghx

Pedelecer
Mar 31, 2011
105
12
Luton, Bedfordshire
I don't understanding this english. I am man! Do you know Deaf is hard read full englsh? Full info the items link and pics sent clear is much better!

My photo there GX12-4 pin (female) wire long to with BBS01:


How battery 10S to BBS01, from pulg to pulg BBS01?
 

trex

Esteemed Pedelecer
May 15, 2011
7,703
2,671
post a picture of the base of the bottle battery cradle, I'll draw over it for you.

GS2.jpg
 

trex

Esteemed Pedelecer
May 15, 2011
7,703
2,671
keep fuse tucked inside base - stop it getting wet by rain.
 
  • Like
Reactions: Gh0stxSinghx

trex

Esteemed Pedelecer
May 15, 2011
7,703
2,671
very important:
One wire per pin, and each wire needs insulation - with 4mm heat shrink sleeve to cover each pin.

the pins must look like this when you finished:



Please remove the new wires and restore the old wires back to the plug where they were.

Please post a picture inside the base, I'll point out for you where the new wires should go.

Watch the video how to solder a wire to a connector
 
Last edited:

Gh0stxSinghx

Pedelecer
Mar 31, 2011
105
12
Luton, Bedfordshire
Well, I have one old solder, not have parts with solder, I can't lots pay for this solder. Can I post to ur address for make wrie and solder my all bottle battery, fuse and wires? when i get all with items package than posted.
 

trex

Esteemed Pedelecer
May 15, 2011
7,703
2,671
Last edited:

Gh0stxSinghx

Pedelecer
Mar 31, 2011
105
12
Luton, Bedfordshire
please restore the GX12 4 pin plug to how it was before the modification.
What mean?

This better. I have heat shrink wire wrap. ordered the solder kit.

Full info is photos all Correct?
 
  • Like
Reactions: trex

trex

Esteemed Pedelecer
May 15, 2011
7,703
2,671
yes, all good GS, you will be OK.
 
  • Like
Reactions: Gh0stxSinghx

Gh0stxSinghx

Pedelecer
Mar 31, 2011
105
12
Luton, Bedfordshire
Two Lipo batterys yesterday delivered, Today I make build finished and tested work now i am happy with that Lipo batterys. :)

You mean: two packs 10s cell 40Volt? ah?

Always use both on bottle battery and two Lipo pack connect to BBS01? When ride bottle battery low end I will bottom turn off, Next Lipo packs auto run?

Soon go ride, Ordered I wait for bag small put two packs.
 

Gh0stxSinghx

Pedelecer
Mar 31, 2011
105
12
Luton, Bedfordshire
you can use the bottle battery or the lipo pack or both for bigger range.
It would be simpler to get a 36V 15AH bottle battery and sell your 9AH bottle battery second hand but where is the fun in that?
If i sell my bottle battry 8ah, best for 36V 15ah lightwieght, how much mlies? I have looking link?

You mean: two packs 10s cell 40Volt? ah?

Always use both on bottle battery and two Lipo pack connect to BBS01? When ride bottle battery low end I will bottom turn off, Next Lipo packs auto run?
 

trex

Esteemed Pedelecer
May 15, 2011
7,703
2,671
have you got your two lipo packs wired together and working? you need to connect them in series to get 42V. With these two packs, you will get about 20 miles.
If you sell your bottle battery and buy a 15AH battery, you get about 55 miles.
 
  • Like
Reactions: Gh0stxSinghx

Gh0stxSinghx

Pedelecer
Mar 31, 2011
105
12
Luton, Bedfordshire

trex

Esteemed Pedelecer
May 15, 2011
7,703
2,671
if you wire in your lipo kit, bottle + lipo kit give about 45 miles.
 
  • Like
Reactions: Gh0stxSinghx
D

Deleted member 4366

Guest
Make sure that your batteries are at the same voltage if you're going to connect them together otherwise you will see a lot of smoke.
 
  • Like
Reactions: Gh0stxSinghx