As long as I can keep the same bottom gear and same gap between gears I've nothing against having a higher top gear I never use. I rarely use my existing top gear on the ebike (Motus hub gear), and never get near it on the non-e bike (derailleur).
It can't be correct that battery can be no more than 48V. It's the power of the motor that's limited to 250W not the voltage required to deliver that power. Power = current x voltage.A legal battery is 48v tops. There has been some discussion here whether that means 48v nominative or 48v maximum. All 48v nominative batteries charge to 54.6v or therabouts.
Battery voltage is easy to enforce, the testing person just needs a volt meter.
Speed is easy to enforce the police just need a speed camera.
That's an interesting point. AFAIK, there is no requirement for a bike to meet the EN15194 standard under UK law. UK law is fairly brief and says that the motor must be rated at no more than 250w, the power must stop when you stop pedalling and the maximum speed allowed is 25km/h. It's EN15194 that mentions "up to 48v".It can't be correct that battery can be no more than 48V. It's the power of the motor that's limited to 250W not the voltage required to deliver that power. Power = current x voltage.
Thanks for the friendly gesture, but I am quite happy with the 25KMH speed limit. Riding on unmade roads is "fun" enough at that speed!It sounds like your gearing is too low. There are plenty of options to make it more comfortable. Tell us or show us what you have if you want suggestions.
Fully correct!It can't be correct that battery can be no more than 48V. It's the power of the motor that's limited to 250W not the voltage required to deliver that power. Power = current x voltage.
The battery is limited in order to stay within EU low voltage limits, nothing to do with e-bike power. Once you get to about 60-72v DC there is a whole lot more legislation to respect in order to prevent electrocution, fires, parasiting your neighbours TV reception ....It can't be correct that battery can be no more than 48V. It's the power of the motor that's limited to 250W not the voltage required to deliver that power. Power = current x voltage.
There is. Two EU countries adopted EN15194 at its introduction, France and the UK.AFAIK, there is no requirement for a bike to meet the EN15194 standard under UK law.
What does adopting EN15194 mean then? Is it illegal to ride a bike that doesn't have reflectors on the pedals? Is it illegal to ride a bike witnout a side stand? Both are requirements for compliance with EN15194.There is. Two EU countries adopted EN15194 at its introduction, France and the UK.
Now with the Great Repeal Bill writing all preceding EU law into UK law, that is permanently the case unless and until parliament acts to change it.
.
Good point!As anotherkiwi has said it would be possible for the police to check speed.
However that in itself does not reveal whether the speed recorded is being achieved legally or otherwise.
I live on top of a hill with the town centre in the valley below and travel close to 30mph down these hills into town with no assistance from the motor, just the weight of the bike, me pedaling and gravity.
Probably, but like so much of pedelec law and indeed other EU law, no-one takes any notice.What does adopting EN15194 mean then? Is it illegal to ride a bike that doesn't have reflectors on the pedals? Is it illegal to ride a bike witnout a side stand? Both are requirements for compliance with EN15194.
But bicycles and legal pedelecs are not subject to our road speed limits, since they only apply to type approved motor vehicles.unless another speed limit is also in force as well, for example a 30 or 40 MPH max speed for that road!
I didn't read about those in EN15194 I think they are in another directive that concerns road worthiness. In French road code pedal reflectors were there long before pedelecs existed and to my knowledge in France there is no obligation for a side stand.What does adopting EN15194 mean then? Is it illegal to ride a bike that doesn't have reflectors on the pedals? Is it illegal to ride a bike witnout a side stand? Both are requirements for compliance with EN15194.
If it is legally a pedalec (or a regular bicycle) then the road speed limits do not apply; or so I understand from recent posts on other threads. If it is NOT a legal pedalec (eg because of max assisted speed) then exceeding the speed limit is another extra detail that could potentially be thrown at you.another speed limit is also in force as well, for example a 30 or 40 MPH max speed for that road!
I believe it is illegal to ride any bike that doesn't have reflectors on the pedals (maybe there is an exception for bikes over a certain age). I hadn't heard about the side stand requirement.Is it illegal to ride a bike that doesn't have reflectors on the pedals? Is it illegal to ride a bike without a side stand? Both are requirements for compliance with EN15194.
I suspect that the law is actually there regarding the Low Voltage Directive. Reading up on legal engineering standards is no task for the fainthearted. Any of these standards make reference to yet other standards again and again and each have specific links. The majority of British Standards were codified under BSI letters and these were transferred where applicable to Euro Standards .. often coded as EN standards. The low voltage directive would have started life as a British Post Office standard ,for telephone exchanges,and grown wings. My recollection is that for a voltage under 60 V the requirement is much relaxed than for voltages above this. Locked cabinets, double layer insulation etc are required. So British law might not have found it necessary to make accommodation for what was already a well regulated activity.That's an interesting point. AFAIK, there is no requirement for a bike to meet the EN15194 standard under UK law. UK law is fairly brief and says that the motor must be rated at no more than 250w, the power must stop when you stop pedalling and the maximum speed allowed is 25km/h. It's EN15194 that mentions "up to 48v".
Yes I researched that a few years ago. You're referring to Extra Low Voltage (BS 7671:2008), which allows up to 120V DC. There's an overlap with the EU Low Voltage Directive, which is for DC voltages above 75V. None of these things are specific requirements for Ebikes, though if you electrocuted someone with your bike, you'd be in trouble if it didn't comply.I suspect that the law is actually there regarding the Low Voltage Directive. Reading up on legal engineering standards is no task for the fainthearted. Any of these standards make reference to yet other standards again and again and each have specific links. The majority of British Standards were codified under BSI letters and these were transferred where applicable to Euro Standards .. often coded as EN standards. The low voltage directive would have started life as a British Post Office standard ,for telephone exchanges,and grown wings. My recollection is that for a voltage under 60 V the requirement is much relaxed than for voltages above this. Locked cabinets, double layer insulation etc are required. So British law might not have found it necessary to make accommodation for what was already a well regulated activity.
As explained a few months back EN15194 doesn't quite work like that, it is a directive. The motor needs to be labelled as 250W, the battery needs to be labelled as 48v max with a CE mark and the frame needs a conformity sticker where the manufacturer (you?) states:Yes I researched that a few years ago. You're referring to Extra Low Voltage (BS 7671:2008), which allows up to 120V DC. There's an overlap with the EU Low Voltage Directive, which is for DC voltages above 75V. None of these things are specific requirements for Ebikes, though if you electrocuted someone with your bike, you'd be in trouble if it didn't comply.
Much of this legality issue comes into play if something goes wrong. Let's say your battery spontaneously burst into flames and sets light to a motorbike parked next to it, so they had to call the fire brigade. I think in that case you'd have some difficult questions to answer when they find bad practice in your wiring, like you used the wrong diameter for the current.
I think when we want to answer the question about whether the bike is legal or not, we mean if a policeman stopped you and checked your bike, what questions would they want answered. If you were able to show a copy of its EN15194 certificate and they can see that the bike is unaltered, you'll be home and dry, as long as the brakes work. I can't see them asking for a copy of the bike's operating instructions showing where it says how to use the charger, which is a requirement of EN15194.
If EN15194 were a legal requirement, can you imagine the situation where you're knocked down by a car driver, who didn't look properly, then the police arrive and ask you whether you have the bike's operating instructions showing how to charge it, and the only instruction you can produce is a home-made one on how to switch on the bike, service the brakes and clean it, so he books you for no insurance, no MOT and no tax because your bike is illegal, as it doesn't meet the requirements of EN15194.