Easier Gear Shifter

[Benjahmin]

Got the changers, the front one seems fully operable. Just ordered a new inner gear cable.
Need to get a hydraulic brake switch so went straight to Topbikekit. Theirs seem to be a 2 wire, think it's a N.C.
The existing Ezee one on the bike is a 3 pin. I don't know if it's N.C. , N.O. or needs the three wires .
Any one know of a 3wire one so I can configure it to suit? Plug type not important as I can cut and join as appropriate.

Bike wiring is all wrapped up at the moment so can't get at it 'till I strip down to do the installation.

 

[Benjahmin]

I've had to order some hydraulic fluid and some pads.
I think I can see a way of using a switch stripped out of the original brake. I'll mock it up with some blu tack to prove, then use some resin putty to set it in place. I'll take some photos as I go.

 

[soundwave]