Search results

Many thanks for your advice. It is much appreciated. Best regards, Kerry

I have managed to turn it upside down and get the torch on it. There is a split in it which I am assuming shouldn't be there. I noticed that as it turned it didn't turn evenly and was further away at some points and closer to at others. I will have to get someone to fix it. Is there anything I...

Thank you. I shall do that tomorrow as it is too dark now to see well. Many thanks for your help. Best regards, Kerry

Many thanks for your speedy response. Where on the bike would the PAS sensor be sited? Thanks, Kerry

Hi Everyone, I have a Freego Wren. When I am peddling the bike suddenly loses power and then suddenly gains it again after a few moments. The best way I can describe it is that it is like a car that is 'chugging'. The power doesn't go completely, but goes very low. It has just started doing...

Issue solved. Issue solved, but there doesn't seem to be a way of deleting the post.

Thank you so much for your help on this as I was totally clueless. I shall get them ordered. Best regards, Kerry

Thank you for the recommendation. I shall have a look for one. One more question, I am probably only going to be soldering electrical wire, so which would be best and what solder do I need to go with it? Many thanks for you help. Best regards, Kerry

Sods law, I got rid of the hot air gun that hadn't been used in years about three months ago! I need to get a soldering iron, but I am clueless as to what to look for when getting a reasonably priced good one - it will hopefully be a rare occasion when I use it. Life it never simple is it...

Thanks for your input. If I move the cable I either connect or don't connect so I assume it is a loose wire. I have tried to unscrew, but it won't move. I wasn't sure if that was because it isn't meant to unscrew or because it pulls apart. You know the shrink wrap, would a hairdryer be...

Hi, Please could you help me with this issue: there appears to be a faulty connection in this section - if I move it back and too it connects then disconnects. Looking on the internet this can be an issue, but the ones shown have screws to remove the cover. How do I get into this one? Does it...

Thanks for the explanation. :)

Ah, right thank you. I didn't know that.

Thanks both of you for your responses. I read online that you should never mix copper and silver wire as it can cause problems. Is that not the case?

Hi, I would be grateful for some help: I have a Freego bike and the mice have chewed the wire that goes from the electric control box at the front of the handlebars to the brake to cut out the motor when I brake. I can't seem to find the same type of wire anywhere - it is two strand blue/black...

Thanks for your input. Unfortunately the nearest place to get it fixed is miles away and I have no transport to get it there.

Hi, Can anyone please advise me of which crimping tool to buy (as cheap as possible as hopefully I will only use it once) to be able to crimp the wires that have come out of the anderson type fitting in my electric controller? I purchased one from screwfix but it is totally unsuitable. I have...

Hi, Can anyone please advise me of which crimping tool to buy (as cheap as possible as hopefully I will only use it once) to be able to crimp the wires that have come out of the anderson type fitting in my electric controller? I purchased one from screwfix but it is totally unsuitable. I have...

Hi, Thanks for your speedy responses. I have managed to get them out, but in so doing damaged one of the pins. :-( Thanks for the link to ebay. I shall order some new ones. Regards, Kerry