Search results

thanks for your reply and interest it is appreciate. All i did was remove the sensor from the chain side to left side and its working perfectly fin. I am trying to work out why. Its away’s been on the chain side and never been a problem. I experienced similar when i an electric conversion...

Tushingham Electric Bikes This electric folding bike came into my workshop, the guy was on holiday in France when his chain may have come off the chain ring and smashed the magnet disc for the PAS He was unable to get it working while on holiday but few days after he was back home brought his...

Anyone know the best replacement Mosfet number for this 36 volts controller used on 250 watts motor

Anyone know the best replacement number for this 36 volts controller used on 250 watts motor

Hi Thank you, I am in the lucky position to have plenty of things in my workshop to try, i have fitted a second hub and that is the same. These are just hubs i have, when i have fitted a complete rear wheel kit they have worked fine. The original hub motor stopped working and i carry all the...

I have fitted a new rear hub 350 watts 9 pin 36v new controller new display its runs okay no speed reading on the display. after half mile shuts down and no power battery is okay. I disconnect the display plug fit in an isolator plug and it runs fine. Connect it all to a front hub and all...

I have fitted a new rear hub 350 watts 9 pin 36v new controller new display its runs okay no speed reading on the display. after half mile shuts down and no power battery is okay. I disconnect the display plug fit in an isolator plug and it runs fine. Connect it all to a front hub and all...

I have fitted a new rear hub 350 watts 9 pin 36v new controller new display its runs okay no speed reading on the display. after half mile shuts down and no power battery is okay. I disconnect the display plug fit in an isolator plug and it runs fine. Connect it all to a front hub and all...

No it’s Yosepower C500 display

thanks for reply Tried a 9 pin new front hub that gives the speed ok but 2 rear new ones no speed reading and take down the road it shuts down

hi have just fitted rear hub motor 9 pin and it’s not showing the speed on my display

I tried that, I had to extend the cable and i managed to take a fraction off the inside of the chain wheel arm and fit the magnet disc and now have it working as it should. Many thanks Ron

Hi I am just doing a electric conversion on a tandem i have fitted a magnet disc on the right hand crank the only crank with no chain wheel but only works if i pedal backwards tried all positions with sensor Any suggestions

Yes 100% they on the axle at 37nm size again 12mm 1.00mm pitch

Nuts 12mm 1.00 pitch was the perfect size

Yes i agree but if they don’t screw on i carnt use them

Hi tried the nuts but not fine enough thread do i need to try 12mm1.00 pitch

Okay many thanks. Ron