New profile posts

Ladies bike with Cyclotricity FWD, Ancheer MTB, Trek roadbike with Yosepower rear hub, Dahon Espresso with front Bafang.
Hi Flecc
Just a short note of thanks for your Panasonic site. It cured to two problems on my second hand Raleigh Leeds tour. Rubber inner tube cured poor connection and reversing sprocket cured clunky engine noise.
The sprocket is 9T will a 11T increase speed. I'm getting about 30miles per charge using mid assist on the 24v 26AH battery.
flecc
flecc
Glad you found the site helpful. An 11 tooth will raise the assist maximum speed to about 17.5 mph but slightly reduce the hill climb ability in each gear. That just means using a next down gear to get the same climb ability. It might slightly reduce the range, but I can't be certain since so many factors influence that.
Could you tell me if the Bluetooth adapter S01-BF5 is it compatible with the Bafang rear motor RM G310 250 DC and the Lishui Controller 1448-2F 36V 15A ?

With this adapter, is it possible to set the maximum speed of the motor and disable the limit speed of 25km/h ?

If yes, just after setting the speed, is it possible to remove the Blutooth adapter or it must remain still connected ?
Hi, I have asked twice if my post in classified can be marked as sold or removed, but I see it has not been done. Please tell me how to either ammend the title to say sold or to remove it. Thanks.
Hi
I posted a question about a battery and wondered if I could ask that you might give it a quick look-over.
Fingers crossed.
Its listed under Gilbern.
Can anyone help me to source one of these brackets for my battery to connect to the connectors. Photo in message
Loving my Cube reaction 500 race, it’s my first ebike, into week 2. Covered almost 200 miles off road so far!
Great looking Bike, I must admit I cover more big hill miles faster on this as opposed to my Cube LTD pro.
hi flecc,
after a bit of advice please,
i have an old cyclamatic powerplus it cuts out when under load (going up hill) switch off the key and on again and it all works then and cuts out again, no issue at all on flat
i think the controller is duff as the battery is fine,
any idea what controller i would need to buy to replace it and from where?
currently saving to buy a newer bike but.........
flecc
flecc
That sounds much more like battery Ian, voltage might look ok but collapsing under load as when climbing. Comments box limits words for reply so best post in forum for full advice.
I
ian831d
will do thanks
In thinking a self generating power by using this dynamo and converter diagram...I'll be use it for my ebike with the voltage of 48volts Phoenix electric bike model..which of my diagram is more recommend for my dynamo? Thank you and more power.
My dynamo is 12V 6W..what converters may you suggest I use to be come 48V?