TSDZ2 and PF30 bottom bracket

[Caoimhín Concannon]

Looking for some advice. I have a Boardman Hyb 8.9 which I'm looking to install a TSDZ2 on. I was about to order when I read that it is not suitable for bikes with pressfit bottom bracket without specially machined shims. It would appear that my bottom bracket is a PF30.
Does anyone have any experience with installing in a bike which had a pressfit bottom bracket? Would using an adaptor like this solve my problem (https://www.chainreactioncycles.com/ie/en/sram-pressfit-30-to-bsa-adaptor-kit/rp-prod71306 ). Thanks

 

[Woosh]

that PF to BSA adapter is OK for the Bafang BBS01B kit but not the TSDZ2 which has the motor about 5mm nearer to the centre of the bottom bracket, too close.
See the note that Videk added to this picture:

https://www.pedelecs.co.uk/forum/threads/whoosh-crank-drive-tongsheng-kit-review.34071/page-2#post-491620

 

[vfr400]

I've seen one done with eccentric adaptors, but you need to get those specially machined.

 

[mimran91]

Looking for some advice. I have a Boardman Hyb 8.9 which I'm looking to install a TSDZ2 on. I was about to order when I read that it is not suitable for bikes with pressfit bottom bracket without specially machined shims. It would appear that my bottom bracket is a PF30.
Does anyone have any experience with installing in a bike which had a pressfit bottom bracket? Would using an adaptor like this solve my problem (https://www.chainreactioncycles.com/ie/en/sram-pressfit-30-to-bsa-adaptor-kit/rp-prod71306 ). Thanks

did you install it in the end? Im only asking because I am considering the hyb 8.9 as a donor bike for the tsdz2

 

[vidtek]

that PF to BSA adapter is OK for the Bafang BBS01B kit but not the TSDZ2 which has the motor about 5mm nearer to the centre of the bottom bracket, too close.
See the note that Videk added to this picture:

https://www.pedelecs.co.uk/forum/threads/whoosh-crank-drive-tongsheng-kit-review.34071/page-2#post-491620

Tony/Andy Thanks for your help with Vaughan's bike, I received the rotor yesterday, will attempt fitting Wednesday at the Men's Shed.

 

[Kierandgaf]

Tony/Andy Thanks for your help with Vaughan's bike, I received the rotor yesterday, will attempt fitting Wednesday at the Men's Shed.

Quick question did you manage to fit the TSDZ2 on the bike. I have found adapter specifically for PF30 to 68-73MM

 

[vidtek]

Quick question did you manage to fit the TSDZ2 on the bike. I have found adapter specifically for PF30 to 68-73MM

The bike to which I referred was a Whoos bike about 10 years old with a mid-drive motor.
I have the Tongsheng TSDZ2 fitted to my own bike.