Torque sensors

[Ahmed55555]

Hi, I have 1500w converted ebike with cadence sensors. Is it possible to fit a torque sensor as it has a better more natural feeling . I have a KT controller with lcd3

 

[vfr400]

The simple answer is no.

Have you set your KT to current control, which they call torque simulation?

 

[Ahmed55555]

The simple answer is no.

Have you set your KT to current control, which they call torque simulation?

I dont think so, I just set it up through the buttons, i heard you can do that on a computer using w firmware

 

[vfr400]

P3=1 is the setting.

 

[Nealh]

Her we go again an electric bike that feel like a push bike !!!!

 

[Edward Elizabeth]

With 1500W its a motorbike that feels like a push bike.

 

[Ahmed55555]

I can use the throttle without the pas but i just wanted a bottom bracket torque sensor instead of the cadence, i hear its possible with a CA3?

 

[vfr400]

I can use the throttle without the pas but i just wanted a bottom bracket torque sensor instead of the cadence, i hear its possible with a CA3?

It's dead easy if you have a degree in computer science. Others might find it a bit more tricky, depending on how much research they want to do, their wiringskills and how much time they want to spend fine tuning the code in the settings. It's not a plug-and-play solution. All the CA does is convert the torque sensor throttle into a throttle signal.