Good Morning,
We are going away next week & I was planning on taking my wiper 705 with me, So husband got it out of garage yesterday to see if he can fit it in the car rather than having to take bike rack, Upon doing so he noticed I had a flat rear tree so pumped it up but it had a puncture so being a mechanical engineer he decided he can sort that out I mean how difficult can it be, he fixes buses so a bike must be simple, anyway turns out not as simple as he thought & he didn't think to consult the manual so now I have no working bike, After lots of shouting about the fact that if I wasn't so fussy I could have just rented a bike on holiday and he only done it to try to help me out he eventually said this is what he done & what the issue is now
Derailleur held on with Allen screw. I removed it to get wheel off. Whether right or wrong. When I put it back on it hits hub cogs. It’s under spring tension and I don’t know what position it needs to be fitted back correctly.
He took it to a local bike repair centre but apparently they were to busy to sort it out or even offer any advice of when they might be able to do it so can anyone please help, I looked at the manual & it states you need to remove the motor cable and a few other bits, I am guessing he didn't do this so could this be the issue & can anyone offer any advice on how he might get my bike back to a working state before I divorce him.
We are going away next week & I was planning on taking my wiper 705 with me, So husband got it out of garage yesterday to see if he can fit it in the car rather than having to take bike rack, Upon doing so he noticed I had a flat rear tree so pumped it up but it had a puncture so being a mechanical engineer he decided he can sort that out I mean how difficult can it be, he fixes buses so a bike must be simple, anyway turns out not as simple as he thought & he didn't think to consult the manual so now I have no working bike, After lots of shouting about the fact that if I wasn't so fussy I could have just rented a bike on holiday and he only done it to try to help me out he eventually said this is what he done & what the issue is now
Derailleur held on with Allen screw. I removed it to get wheel off. Whether right or wrong. When I put it back on it hits hub cogs. It’s under spring tension and I don’t know what position it needs to be fitted back correctly.
He took it to a local bike repair centre but apparently they were to busy to sort it out or even offer any advice of when they might be able to do it so can anyone please help, I looked at the manual & it states you need to remove the motor cable and a few other bits, I am guessing he didn't do this so could this be the issue & can anyone offer any advice on how he might get my bike back to a working state before I divorce him.