Hi everyone. Hope this is the right place for this thread. If not, feel free to move it mods.
I'm gauging interest on a possible group buy for the new "V3" MXUS 3K Turbo direct drive hub motor.
Specs as follows:
- Nominal wattage: 3000W
- Peak wattage: 6000W
- Voltage: 48V - 96V
- 3T or 4T windings
- Torque Constant (Kt): 3T = 0.8Nm/A, 4T = 1.07Nm/A
- RPM per volt: 3T = 11.9Kv, 4T = 8.9Kv
- Lamination Size: 0.35mm
- Stator/Magnets: 45mm
- Max Efficiency: 90% peak
- Temp sensor
- 9.3kg
- 142mm dropout
- 4mm² phase wires
- 38H bended magnet
- 6004 Bearing 20mm id on wire side
- 20mm axle (wire side), 17mm axle (non wire side)
- Double set of hall sensors
I'm gauging interest on a possible group buy for the new "V3" MXUS 3K Turbo direct drive hub motor.
Specs as follows:
- Nominal wattage: 3000W
- Peak wattage: 6000W
- Voltage: 48V - 96V
- 3T or 4T windings
- Torque Constant (Kt): 3T = 0.8Nm/A, 4T = 1.07Nm/A
- RPM per volt: 3T = 11.9Kv, 4T = 8.9Kv
- Lamination Size: 0.35mm
- Stator/Magnets: 45mm
- Max Efficiency: 90% peak
- Temp sensor
- 9.3kg
- 142mm dropout
- 4mm² phase wires
- 38H bended magnet
- 6004 Bearing 20mm id on wire side
- 20mm axle (wire side), 17mm axle (non wire side)
- Double set of hall sensors