Motorbike headlight

[trevor brooker]

I only attach this headlight after dark - 2 bolts & 3 push wires.
I replaced the 12v bulb with a multi voltage side mounted LED that uses the reflectors, so I have the cut off on dipped to prevent blinding drivers. The 3rd wire is for main beam as I have country lanes to navigate before I get to any town.
I used a splitter off the main battery cable to a waterproof box, inside is an inline fuse.
I looked at the MOT for bikes & decided that if that is what is deemed sensible for safety for road use, then I should aim for the same.
So indicators mounted on handlebar mirrors (only used at night as arm signals during the day are clearer)
Also flashing white LEDs (Red at back) at widest part of cycle to emphasize the width (when I was doing a 10 mile single lane country road I experimented with all types & positions of lights & I found that the wider you appear the more space you are given)
During the day I just have the front fork cycle lamp (also with cut off) so I also have a light if needed.

 

[guerney]

I very much like this idea! I've been impressed by some motorcycle headlights - they're sometimes so bright that they look very noticeable in bright daylight. What headlamp is that? Did you get the clamps with the headlamp, if not, what are they called and where can I get them?

Were the multi-voltage LEDs easy to source? Is the overall brightness of your light, similar to the 12V bulb they replaced, or are they brighter?

How did you make the indicator lights? Did you use a motorbike part to make the bulbs flash? 12v? Or did you make your own, and if so, how?

 

[trevor brooker]

I did it to be as cheap as possible as I had no income.

If I was to do it again & wanted to leave it permanently attached I would look at
the small twin motorbike headlamps, which when I looked only took 12v bulbs, so would need a 12v convertor.

 

[guerney]

If I was to do it again & wanted to leave it permanently attached I would look at
the small twin motorbike headlamps, which when I looked only took 12v bulbs, so would need a 12v convertor.

The last converter I tried killed my controller (but my terrible [at the time] soldering skills, may have been a major factor), so I'd much rather use multi-voltage LEDs.

 

[trevor brooker]

I very much like this idea! I've been impressed by some motorcycle headlights - they're sometimes so bright that they look very noticeable in bright daylight. What headlamp is that? Did you get the clamps with the headlamp, if not, what are they called and where can I get them?

Were the multi-voltage LEDs easy to source? Is the overall brightness of your light, similar to the 12V bulb they replaced, or are they brighter?

How did you make the indicator lights? Did you use a motorbike part to make the bulbs flash? 12v? Or did you make your own, and if so, how?

The headlight was ebay (12v 7 INCH MOTORCYCLE MOTORBIKE HEADLIGHT HEADLAMP ROUND HALOGEN... Total: £7.99 )

The bulb was ebay (12W 12V-85V H4 3LED Motorcycle Headlight Bulb Hi Lo Scooter Lamp / ATV Fog Light... Total: £1.98)

The indicators/front white flashers/rear red flashers were ebay (12V-85V Car Truck Flashing Emergency Warning LED Strobe Lights Flasher W... Total: £3.29)

The brackets were ebay (Sport Bike Bicycle Water Bottle Cage Holder Clamp Clip Handlebar Bracket... Total: £2.98) as I had to find those that split in two for ease of removal plus I bent a piece to metal to make the join between the headlight & the brackets.

Overall the effect is very good but not aesthetically pleasing.

The beam is bright (similar to car) & broad & very noticeable. Last night on the way back from the shops they closed one lane of the dual carriageway so all of its traffic was coming towards me, overtaking the cars parked on that side, but all of the vehicles stopped behind the parked cars to allow my right of way, because what they could see was a headlight not a cycle.

 

[guerney]

Overall the effect is very good but not aesthetically pleasing.

The beam is bright (similar to car) & broad & very noticeable. Last night on the way back from the shops they closed one lane of the dual carriageway so all of its traffic was coming towards me, overtaking the cars parked on that side, but all of the vehicles stopped behind the parked cars to allow my right of way, because what they could see was a headlight not a cycle.

That's an excellent effect! And I like the way it looks.

 

[guerney]

I've got three small headlights wired to the battery via an inline fuse (waterproof mini blade 3A fuse, wrapped in self-amalgamating rubber tape to further waterproof) - two on the handlebar and one in the fork... but adding a motorcycle headlamp like yours in the middle, may well be next! Plus indicators, I miss motorbike indicators... especially at roundabouts.

 

[guerney]

I replaced the 12v bulb with a multi voltage side mounted LED that uses the reflectors

What are those called, or do you happen to have a link? I might to pair with this you've already mentioned, for a mega-bright light:

12W H4 3led Motorcycle Headlight Bulb Hi Lo Scooter Lamp / Atv Fog Light Lamps for sale | eBay

Find great deals on eBay for 12W H4 3led Motorcycle Headlight Bulb Hi Lo Scooter Lamp / Atv Fog Light Lamps. Shop with confidence.

www.ebay.co.uk

 

[trevor brooker]

What are those called, or do you happen to have a link? I might to pair with this you've already mentioned, for a mega-bright light:

12W H4 3led Motorcycle Headlight Bulb Hi Lo Scooter Lamp / Atv Fog Light Lamps for sale | eBay

Find great deals on eBay for 12W H4 3led Motorcycle Headlight Bulb Hi Lo Scooter Lamp / Atv Fog Light Lamps. Shop with confidence.

www.ebay.co.uk

The above link is for forward facing LEDs so fine for spot lights but no good for dipped beam as they look like normal torch lights from oncoming traffic. I know I made that mistake.

To get the headlight reflectors & glass prisms to work you need side LEDs

https://www.ebay.co.uk/sch/i.html?_from=R40&_trksid=p2334524.m570.l1313&_nkw=+h4+12+-+80v+bulb&_sacat=0&LH_TitleDesc=0&_odkw=+(12W++H4+3LED+Motorcycle+Headlight+Bulb+Hi+Lo+Scooter+Lamp+/+ATV+Fog+Light&_osacat=0

 

[guerney]

The above link is for forward facing LEDs so fine for spot lights but no good for dipped beam as they look like normal torch lights from oncoming traffic. I know I made that mistake.

To get the headlight reflectors & glass prisms to work you need side LEDs

https://www.ebay.co.uk/sch/i.html?_from=R40&_trksid=p2334524.m570.l1313&_nkw=+h4+12+-+80v+bulb&_sacat=0&LH_TitleDesc=0&_odkw=+(12W++H4+3LED+Motorcycle+Headlight+Bulb+Hi+Lo+Scooter+Lamp+/+ATV+Fog+Light&_osacat=0

I very much like the idea of three of those in the middle of one housing = 75W = 7800lm

 

[guerney]

One in the middle and three surrounding it = 105.6W = 2.93A = 9600lm:

White H4 HS1 CSP LED Motorbike Headlight Bulb Car Fog Lamp Hi/ Lo Beam AC/DC 12V | eBay

Item: H4 9003 HB2 HS1 P43t. High Power CSP LED, so bright at 2400LM. Chip: CSP LED. Fit for: Motor Headlight Light/Car Fog Lamp/DRL. DC 10-30V suit for most motorbikes and cars. Life span: 50000 hours.

www.ebay.co.uk

 

[soundwave]

Original XHP70.2 XHP50.2 6V&12V 6000K to 3000K LED Chip Bulb Lamp 26MM Driver | eBay

Find many great new & used options and get the best deals for Original XHP70.2 XHP50.2 6V&12V 6000K to 3000K LED Chip Bulb Lamp 26MM Driver at the best online prices at eBay! Free delivery for many products.

www.ebay.co.uk

note at 6v that led will draw near 5a so will need a hefty heat sink to work at full power.

 

[guerney]

Original XHP70.2 XHP50.2 6V&12V 6000K to 3000K LED Chip Bulb Lamp 26MM Driver | eBay

Find many great new & used options and get the best deals for Original XHP70.2 XHP50.2 6V&12V 6000K to 3000K LED Chip Bulb Lamp 26MM Driver at the best online prices at eBay! Free delivery for many products.

www.ebay.co.uk

note at 6v that led will draw near 5a so will need a hefty heat sink to work at full power.

Those LEDs areimpressively bright, but they can't seem to operate for very long at full brightness - cooling them will be a problem. I'm really bummed out that that in no video did they show what the beams of any of their torches looked like, in bright daylight - I've seen some motorbike headlamps look impressively bright during the day, noticeably bright.

 

[soundwave]

if your going 60mph that should be enough to cool it down i dont put my light on full beam unless im going fast enough as the heat sink gets hot and eats the batt range if not moving.

and tbh on full power down the cannel it is only just powerful enough when going 30mph in pitch black

carrots don't work pmsl

 

[guerney]

if your going 60mph that should be enough to cool it down i dont put my light on full beam unless im going fast enough as the heat sink gets hot and eats the batt range if not moving.

and tbh on full power down the cannel it is only just powerful enough when going 30mph in pitch black

carrots don't work pmsl

How many lumens is your light? I reckon my 3w X 3 Bafang/Junstar combination (wired to my ebike battery) is likely about as bright as that in total darkness. I'll have to check. Trouble is - I have to travel a loooong way to find somewhere completely dark, which isn't infested with psychotic loonies.

 

[soundwave]

that was my old cree light the magic shine mj 908 is 8000lm but is about 5000 -6000lm as not every led can be run at full power.

 

[guerney]

that was my old cree light the magic shine mj 908 is 8000lm but is about 5000 -6000lm as not every led can be run at full power.

View attachment 44674View attachment 44675
View attachment 44676
View attachment 44677

How many lumens was it set to for the above night video?

 

[soundwave]

was one of these

Solarstorm X3 Bicycle Headlight 3x U2 4 Modes 3000 Lumens LED Bicycle Front Lights

Product detail : 1. Can Be fixed on the bicycle, as front bike headlights used 2. With a adjustable headband, as a headlight used. 3. Waterproof (IP65), O-shaped ring, heavy rain is still normal use 4. Use 3 pieces U2 LED, intelligent control circuits

gb.ledsupermall.com

 

[guerney]

that was my old cree light the magic shine mj 908 is 8000lm but is about 5000 -6000lm as not every led can be run at full power.

View attachment 44674View attachment 44675
View attachment 44676
View attachment 44677

It looks a lot brighter in those photos than it did on your video. Auto-exposure on video? If it's an uneven spread, most cameras on automatic (unless programmed otherwise) will expose correctly for the brightest area, making everything else look darker.

 

[guerney]

was one of these

Solarstorm X3 Bicycle Headlight 3x U2 4 Modes 3000 Lumens LED Bicycle Front Lights

Product detail : 1. Can Be fixed on the bicycle, as front bike headlights used 2. With a adjustable headband, as a headlight used. 3. Waterproof (IP65), O-shaped ring, heavy rain is still normal use 4. Use 3 pieces U2 LED, intelligent control circuits

gb.ledsupermall.com

Aha, my three at 5w 36v are pulling just a bit less than that - just shy of 1A, which explains why the brightness looks (to me) about similar, to that light?