KT-LCD2, KT-LCD3, KT-LCD6, KT-LCD8, KT-LCD10 replacement button assembly mounting bracket

[Nealh]

Go to Daniels web site the link is in #39.

 

[Andy1865]

Go to Daniels web site the link is in #39.

Thanks Neal

 

[portals]

So I was tightening the bracket on KT LCD 8 and managed to snap it where the screw goes through the loop :-(

I found Daniels website and ordered his 3D PLA printed replacement for £4.

Later on I found the .stl file on thingiverse so I've just 3D printed a prototype on my Creality CR6-SE (SUNLU PLA+ black at 220C/80C on magnetic PEI plate), as Daniels' hasn't arrived yet, it took approx 1hr 20mins at 0.2 res (low quality)/100% infill

I had to snap off rest of loop from controller to fit it however when you line it up and tighten screw it works well and holds buttons securely in place, I was a little sceptical but it does work great!!

It also 'lifts' the buttons by a few mm so I can slide it tight against my LHS brake whereas before I had to leave 3mm to stop it fouling.

Win win!

Currently printing another one at 0.12 res (high quality) now I know it works well.

 

[portals]

Was playing with the design earlier and have remixed it on thingiverse, only change is making the lugs deeper to help it sit straight when tightening, kudos to Daniel for original design.

Bracket REMIX