King-Meter J-LCD cannot get to system settings

[bluetempleton]

Would love some help. Have a king meter J-LCD. Trying to access the System Parameter Setting. I can get into the basic setting pressing up and down buttons. Manual says to press up and down button for 2 seconds then press up and down again for 2 seconds and this should put us into system settings,
I’ve tried a few combinations up and down for 2 seconds then up and mode for 2 seconds etc. but cannot get access to system settings.
Any ideas?

 

[Nealh]

Some may be dealer locked to prevent fiddling.
I found Lishui/kingmeter stuff unuser freindly , the Lishui is for oem dealers who have access to there programming software to make changes.

 

[saneagle]

I can't remember exactly how to do it, but try this:
1. Press and hold the up and down buttons to get into the basic settings, then press and hold for ten seconds to get to the advanced ones.
2. Press and hold the up and down buttons to get into the basic settings, then cycle through those settings until you get to the end, then press and hold again to goto the advanced ones.

 

[Woosh]

You press both up and down buttons at the same time and keep holding them down for 2 seconds or until you see the lcd flash.
Manual is here https://wooshbikes.co.uk/?manuals

 

[bluetempleton]

Have the manual. Getting to basic settings is easy. however It won’t enter the Advanced setting using any combination as suggested.

You press both up and down buttons at the same time and keep holding them down for 2 seconds or until you see the lcd flash.
Manual is here https://wooshbikes.co.uk/?manuals

 

[Woosh]

Which bike have you got?

 

[bluetempleton]

Crooze

 

[Woosh]

your JLCD may be locked. If that is the case, there is no more you can do.

 

[bluetempleton]

your JLCD may be locked. If that is the case, there is no more you can do.

Thanks. Would any bike shops know how to tap into these settings or can it all be reset?

 

[Woosh]

there are only a few settings you can change in a JLCD: the clock, tyre diameter, speed limit.
AS the values are stored in the JLCD and load into the controller when you switch on the bike, if your JLCD is locked, you are stuck with the preset values.