Error "06 info" on lcd?

[borgqueenx]

Copper coils and varnish!
The varnish acts as insulation stopping the copper coils from short circuiting.
If the insulation is broken, a short forms. This bypasses the coil windings, Reduces the reluctance and causes low drive and high current. Bringing on very hot wires. And finally the magic smoke.
Hence circuitry to detect shorts and raise error message. And lots of advice here on metering the motor to detect.

Is there a way to check this? I hopefully get my new controller today or tommorow by the way...

 

[borgqueenx]

today i got the new controller and installed it. the wires for the pedal sensors were not correct, had to rewire them. also the power connector was different. nothing that cant be fixed though. the bike is fully working again and this time its easy to connect the lights. It got a clear wire that will output the battery voltage when the light on the LCD is enabled. Next up is receiving the lights themselfs and the usb charger.
I would like to thank everyone for their help! Hope the bike will survive for more then 2 days now lol!

 

[that_guy]

I just had this problem and it turned out to be that my fuse was loose.