Custom Firmware for KT Controller
- Thread starter Sparksandbangs
- Start date
To me, the standard firmware seems to be pretty good. What do you want to improve?
Nothing really. I just like the idea of tinkering with things. An ability to change the assist output percentages might be useful.
Last edited:
what exactly? have you set your throttle as a power over-ride with P4=1 and C4=3?
All working correctly. Throttle override is set up like that with P4 at 1 and C4 at 3.
I was thinking that if I upped the maximum power that I might like assistance 1 to be a bit tamer. Dropping it from 13% to a lower value.
You know about the custom firmware project on Endless Sphere? It went on for a while, but is no longer supported.
My wish list for KT firmware would be
1. Input wheel diameter in mm, not presets.
2. Keep a default C5 of 10 on assist level 4 always, Then you don't lose max current.
However, if this were available in custom firmware, it's not worth the headaches to install. The KT works great. Why complicate or break it,
My wish list for KT firmware would be
1. Input wheel diameter in mm, not presets.
2. Keep a default C5 of 10 on assist level 4 always, Then you don't lose max current.
However, if this were available in custom firmware, it's not worth the headaches to install. The KT works great. Why complicate or break it,
Can you explain point 2 again in a simple way for thicko? I can't make any sense from it. My C5 is on 10, and it never changes.
Related Articles
-
Swytch announce new conversion kit with ‘pocket-sized’ battery- Started by: Pedelecs
-
New Swytch launches on Indiegogo, raises £100k in first hour- Started by: Pedelecs
-
Swytch to unveil 70% smaller, 50% lighter conversion kit- Started by: Pedelecs