Controller help

[mark71070]

I would need a link to it, not a photo.

Pardon our interruption...

 

[saneagle]

Pardon our interruption...

It would work, but why would you want to use that one? It has no control panel, so you'd need to find and install a switch somehow. It has the useless three-speed switch which requires another switch (3 position), and they don't tell you the size, so you could end up with another one that doesn't fit.

 

[mark71070]

It would work, but why would you want to use that one? It has no control panel, so you'd need to find and install a switch somehow. It has the useless three-speed switch which requires another switch (3 position), and they don't tell you the size, so you could end up with another one that doesn't fit.

OK that's understandable

 

[mark71070]

So the 1st one you linked to would be a better bet then
Appreciate all the help so far mate

 

[saneagle]

So the 1st one you linked to would be a better bet then
Appreciate all the help so far mate

Yes, but it says it's only 13A, so 87% of the power of your original. You can get more power by adding a bit of solder to the shunt inside of it. the shunt is a piece of metal that looks like a staple. If you solder 10% of its length, you get 10% more power. Normally, just soldering up one leg is about right. That's if you need the power. Another thing is that it'll be unrestricted, so might be illegal, depending on your motor's max speed.

The LCD ones are a lot better, but they cost more.

 

[mark71070]

OK ty for that
Only want basic for now just to get backward n forward to work n fishing
Also that would fit in its original place due to its size

 

[mark71070]

Pardon our interruption...

 

[mark71070]

Got this one on its way