As noted re-celling is not cheap but the quote I had from Jimmy of £300 for my 8.8A battery would have upgraded it to 14A & the price included collection & return by courier.Usually gradually, one will notice range decreasing or battery capacity use is higher for a set distance. Typically the battery voltage will sag using high load esp up hill and the bike will cut out, try it in highest assist level and a steep hill to see if it is so.
A new battery will likely be quite dear but you can get the case re- celled for about half the price esp if the battery is over £500 new.
Ebikebatteries.co.uk in North London will do the job for you and arrange courier pick up both ways, depending on the cells used expect about £250 - £300 for the work to be done. Phoning using the number on the website is best, Jimmy is a great guy.
At about half the price of very expensive new batteries for some bikes and at some 60% more capacity the cost would be well worth it.As noted re-celling is not cheap but the quote I had from Jimmy of £300 for my 8.8A battery would have upgraded it to 14A & the price included collection & return by courier.
Sometimes better I would say as some of these re-cell companies seem to use the very best latest batteries where as that isn't always true of even brands like Bosch. However Bosch warn against re-celling.At about half the price of very expensive new batteries for some bikes and at some 60% more capacity the cost would be well worth it.
If one used logic the £300 re- cell would be equal to about an £800/£900+ proprietary battery from the maker if using the same capacity.
It is very possible. There is no law of physics preventing it - it is just a goodly job of work, and requires some skill and knowledge. Indeed, it's relatively straightforward in some regards as it's nowhere near as complex as fully networked Canbus of the sort you would find in a modern car, and even they aren't that difficult to modify and play with if you know what you're about. The biggest issue is obtaining the info and diagrams to understand how the multiplexing is set up in order to either transplant it or duplicate it, but once you have that the job itself is very doable. Just because you don't know how to to it doesn't mean others can't.Option 3 is not possible for mid drive, Bosch, Yamaha or Shimano etc, etc.
Generic batteries will not have the Canbus handshaking protocols.
Good post.Options.
1. Buy a new battery.
2. Get the existing battery re-celled. This may be the favoured option. Cost effective, liable to have greater capacity than new, and requires no modification on your part.
3. Invest in a generic battery replacement, possibly of far greater capacity than the original. This may be relatively straightforward, or it could be more complicated if the controller is housed in the base of the existing battery holder. In either case it's not difficult, just more involved.
I'd consider 2, 3, 1, in that order. Good luck.
Good point.Option 3 is not possible for mid drive, Bosch, Yamaha or Shimano etc, etc.
Generic batteries will not have the Canbus handshaking protocols.
Thanks for the reply as it's very informativeUsually gradually, one will notice range decreasing or battery capacity use is higher for a set distance. Typically the battery voltage will sag using high load esp up hill and the bike will cut out, try it in highest assist level and a steep hill to see if it is so.
A new battery will likely be quite dear but you can get the case re- celled for about half the price esp if the battery is over £500 new.
Ebikebatteries.co.uk in North London will do the job for you and arrange courier pick up both ways, depending on the cells used expect about £250 - £300 for the work to be done. Phoning using the number on the website is best, Jimmy is a great guy.