August 15, 20205 yr Hi! I was just wondering if anyone here who owns a Citylignt 3E MK II bike had a copy of the instructions manual? I was bought the bike as a present, and it didn’t come with an instruction booklet, and could do with resetting the mounted cycle computer cheers
August 16, 20205 yr These are often generic. If you give the number on the display or post a photo of it it's more likely someone can help.
August 16, 20205 yr That display has nothing specifically to do with your e-bike... it's a standard, generic aftermarket cycle computer which has been added to the bike. https://www.amazon.co.uk/Etc-Mach-1-Bicycle-Computer-Functions/dp/B000ZOWJZU If you're unlucky finding instructions, just try pressing/holding buttons down until the display starts to flash (likely a set mode), and then scrolling through to see what's what. If you can't work out how to set/reset it by trial and error, just chuck it away and replace it with another off ebay/Amazon. They're only a couple of quid to buy new (with instructions).
August 16, 20205 yr Author That display has nothing specifically to do with your e-bike... it's a standard, generic aftermarket cycle computer which has been added to the bike. https://www.amazon.co.uk/Etc-Mach-1-Bicycle-Computer-Functions/dp/B000ZOWJZU If you're unlucky finding instructions, just try pressing/holding buttons down until the display starts to flash (likely a set mode), and then scrolling through to see what's what. If you can't work out how to set/reset it by trial and error, just chuck it away and replace it with another off ebay/Amazon. They're only a couple of quid to buy new (with instructions). I would take it off, but it seems to be wired in some how. I actually bought a replacement and then realised it was hardwire in
August 16, 20205 yr The display usually clips onto the handlebar bracket for easy removal. Unclip the display and remove the old bracket from the handlebar. For a wired cycle computer, there will be a single cable which runs from the computer bracket down the leg of the front fork (usually on the left). There will be a small sensor mounted at the end of this cable on the inner side of the fork. Cut any ties/tape which hold this cable and sensor and remove. On one spoke of the front wheel will be a small magnet which passes the sensor when the wheel turns (this is how the computer measures wheel rotation for speed & distance). You can remove that too or leave it for your replacement.
Join the conversation
You are posting as a guest. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.