Recent content by Matthew Hutchinson

Hi all, just thought I would update you where I am with this and what my thoughts are next, so I wanted to ensure that my problems weren't down to a bad connection so to remove any chance of it being my crappy soldering I just cut all my connectors off and used wago and guess what, it was...

Thanks for that, I'm starting to get my head round it all on a very basic level, probably famous last words when my next controller doesn't work either lol

I'm going to take a punt and try a new controller I just have a couple of questions, are led810 displays protocol 2 and when a controller says suitable for 1000 watt is that an upto 1000 watt or are controllers wattage specific, I'm guessing it's up to 1000 watt but it would appreciate...

Looked over my other trike and there is no difference in the sett up, i tested second wheel and throttle on that trike and they are all good so then I swapped out the phase bullet connectors for xt60s and guess what, no difference so it must be the controllers , are there no other controllers...

Tomorrow I'm going to change tire on the other trike so while I'm at that I will check if there is anything different on that one, I'm hesitant to start taking that one to bits and testing it with parts from the other because it's my only way of getting about, if I break that I'm trapped indoors...

Yeah you are right tried them all, there was a couple of configurations that gave me the same results as standard wiring but the rest have no movement whatsoever. Disconnected the sensor wires completely and it's still exactly the same problem. I am finding if I accelerate gently I can get up to...

Lovely thanks for that it is very much appreciated

Can you tell me what the black arrows represent, does it mean short between those two contacts?

So here it is atm plus picture of pins on wheel cable which all look good.

I've changed the wheel and the lead since that photo so it's all in the correct order and yes the mirror cable is to the line, I'm going to take the controller off the trike later and I will lay it all out then you can see everything easily in case I'm missing anything obvious

Yeah seen thank you, I've started going through the different combinations, it will probably take me a couple of days so I will let you know how it's going as soon as it is done, I will keep an eye on the connector pins. Not sure if this tells us anything but if I run with the sensors...

Thanks for your input, can I just check before I start testing that I'm understanding this correctly, the top box tells me the changes to make in the sensor connection and the boxes below are changes to the phase wire connections, so I just swap them about as it says until I find one that works...

Motor cable is fine, tested trike with two motors and the issue remains so I think its fair to say they are good, brand new hub so no moisture issues, I'm just debating on changing the bullets for xt60s and see if that gets me anywhere

Is it worth changing the bullet connectors on the phase wires for xt60s

So the 11amp controller would be fine with the 20ah and 17ah battery, that's a bitch I really thought I had found the issue then