suggestions for feeding ebike electric cables into frame vand out by the bb

[footpump]

hi all I have the yosepower/elife shop rear 350w moter wheel 26"

I am going to try to fit this o kudos vita uno mtb, which will give me 5 levels of assist instead of 3
not fully decided on wether to fit thumb throttle which I could set to full speed or less?

the existing cables run through the top of frame and out in the bb area.

the new kit uses Juliet cable system , not sure what is the best method of feeding cables into and out of the frame.

or if its wise to just affix to outside of frame

 

[Deleted member 4366]

You need something like this to thread the cable through:

https://www.ebay.co.uk/itm/Non-Conductive-Fibreglass-Cable-Rod-Kit-12-Piece/391618881595?hash=item5b2e4de83b:g:6~4AAOSwAaJaG9ab

It's certainly easier to run externally.

 

[Gringo]

I'm pulling things through tubes every day
It always starts with me drawing a thread through with a vaccuum