PRO RIDER CONTROLLER

[peteske]

The electronic control board has burnt out on my Pro Rider bike.. in fact the load resistor
Do you have contact address for ECO ELEKTRISCH FIETSEN printed circuit control box.
Or could anyone sell me one, or wire in equivalent?
I know its a long shot... I LIVE IN UK
thanks, pete

 

[vfr400]

These are standard Chinese parts that you can buy from Ebay, Aliexpress, Amazon and Chinese resellers. They're not specific to Pro Rider.

Show a picture of the controller that's under the battery. We need to see all the wires and connectors, especially the connector/s to the control panel, to get a good match.

 

[peteske]

Thanks for replying - i appreciate that.
Sounds good that you think they might be available.
I have not found any contacts on sites you listed and not sure what 'the controller that's under the battery means ?? this is the insides of controller and the melted resistor is the black burnt blob under lights.
Is it familiar??
pete

 

[vfr400]

What I need to see is at the other end of the wire under the battery.

 

[peteske]

I hope this is what we need - red and black = +ve and -ve
pete

 

[vfr400]

If you peek through that hole, you can just about see the controller. You access it by removing the panel on the side of that compartment, not from the top.

 

[peteske]

I hope this helps??
pete

 

[vfr400]

The wires are too tangled and hiding all the connectors. See post #2.