Woosh Mxus xf08c cassette bearings failure

[ochillr]

Hi I have a MXUS Xf08C ebike rear wheel conversion, I recently found the cassette freewheel bearings badly worn and need to remove the inner bearing track from the motor end plate does anyone have any knowlege of this .

 

[Nealh]

I 've not opened a mxus so not can't say, some freehubs on these end plates are removable and some aren't.
My Q128C isn't removeable and one has to buy a complete new end plate assembly , my Bafang CST is removeable once the end plate is off.

Best speak to Woosh as they may carry spares if it isn't removeable.

d8veh/saneagle will likely know for sure.

 

[saneagle]

I 've not opened a mxus so not can't say, some freehubs on these end plates are removable and some aren't.
My Q128C isn't removeable and one has to buy a complete new end plate assembly , my Bafang CST is removeable once the end plate is off.

Best speak to Woosh as they may carry spares if it isn't removeable.

d8veh/saneagle will likely know for sure.

I'm not 100% sure because I get them mixed up in my head, but I think the MXUS freehub just pulls off after removing the nut, though it's possible that they could have changed it. I know you can get two versions of Bafang CST from the same time, so anything is possible.

 

[Woosh]

The xf08c is very easy to open. You only need a screwdriver to remove the 6 screws then tap gently on the side of the lid to pop it out. The freehub body can be dismantled for servicing but I would recommend a replacement. We keep spare lids.
Please email support@wooshbikes.co.uk, Andy will help you.