Hello,
I'm trying to configure a kit from scratch. So its ugly but looking to test the setup before reducing wires down etc
Kit consists of:
Battery case holder with integrated KT 15A sinewave controller
Yose 10Ah battery of similar design
KT LCD4 display
Cyclotricity 12 pole PAS Sensor
9-pin extension cable from internal controller to front hub motor
System cable from internal controller to LCD4 with unused brake sensors and throttle attachments
Test 1. Front Hub 250W Motor Cyclotricity
Test 2. Front Hub 250W Motor LVBU
The LCD4 shows full battery and recognises speed when I peddle.
The PAS sensor light flickers when the pedals are turned.
The motor cables are fully engaged.
So I'm trying to understand if this is an incompatible motor problem or whether I'm meant to set some parameters with the LCD4. I'm just looking to get everything talking to each other and power on.
Any clever people offer any advice please?
Relevant photos are attached.
I'm trying to configure a kit from scratch. So its ugly but looking to test the setup before reducing wires down etc
Kit consists of:
Battery case holder with integrated KT 15A sinewave controller
Yose 10Ah battery of similar design
KT LCD4 display
Cyclotricity 12 pole PAS Sensor
9-pin extension cable from internal controller to front hub motor
System cable from internal controller to LCD4 with unused brake sensors and throttle attachments
Test 1. Front Hub 250W Motor Cyclotricity
Test 2. Front Hub 250W Motor LVBU
The LCD4 shows full battery and recognises speed when I peddle.
The PAS sensor light flickers when the pedals are turned.
The motor cables are fully engaged.
So I'm trying to understand if this is an incompatible motor problem or whether I'm meant to set some parameters with the LCD4. I'm just looking to get everything talking to each other and power on.
Any clever people offer any advice please?
Relevant photos are attached.
Attachments
-
189.1 KB Views: 5
-
621.2 KB Views: 5
-
130.4 KB Views: 6
-
103.8 KB Views: 6
-
137.7 KB Views: 6