How to reduce crank turns for p.a.s

[Andy1865]

Hi All. My p.a.s has 12 magnets and is set to 12 on M5 display, the other two are 8 and 5 which have no effect. The sensor is 1 to 2mm away from the bottom bracket. I have to do 3 full crank turns before p.a.s kicks in. Does anybody know of how to reduce the turns so that i get p.a.s quicker.
Thanks.

 

[saneagle]

Hi All. My p.a.s has 12 magnets and is set to 12 on M5 display, the other two are 8 and 5 which have no effect. The sensor is 1 to 2mm away from the bottom bracket. I have to do 3 full crank turns before p.a.s kicks in. Does anybody know of how to reduce the turns so that i get p.a.s quicker.
Thanks.

Get a new controller.

 

[Peter.Bridge]

Hi All. My p.a.s has 12 magnets and is set to 12 on M5 display, the other two are 8 and 5 which have no effect. The sensor is 1 to 2mm away from the bottom bracket. I have to do 3 full crank turns before p.a.s kicks in. Does anybody know of how to reduce the turns so that i get p.a.s quicker.
Thanks.

Does the sensor have a little light on ? If you turn the display on , level 0, then turn the pedal (will need to lift back wheel up) does the light come on as each magnet passes the sensor

 

[Nealh]

If you can't improve the rotation timing , then think about retrofitting a KT system. PAS with my 10 pole count kicks in within an 1/8th turn.

 

[Nealh]

Three rotations to engage PAS is terrible, the lag is down to the software logorythm's which can'e changed. Some controllers are just crappy.