Help with pas settings

[appaddy]

Hi all,

Just got a new kunteng lcd1 dashboard but not convinced the pas settings are correct. All connectors are tightly closed but I have now power to the motor. This is from both the twist throttle and pas sensor (which is lit up when peddling). My kit was from panda e bikes and is a 250W 36V 10amp battery. Have had to adjust pas 5 from 12 to 0 already(after tadvice) to get the battery power to show.

Hope someone can help

Thanks in advance

 

[Wheel-E]

Can you retrieve the settings from your old display? What was your old display and does your bike still work if you plug that in?

 

[D C]

You can download a manual from here:

http://www.szktdz.com/upload/file/20140814/20140814015208_34156.pdf

Useful to have but may not solve your problem.
It's best to make a note of the existing settings before you change anything then you can get back to where you were.

Dave.

 

[Nealh]

You need to check that the lcd wiring sequence match's on the connectors there are 5 wires and needs colour to colour to match.

 

[Deleted member 4366]

You need to check that the lcd wiring sequence match's on the connectors there are 5 wires and needs colour to colour to match.

In most cases, but not always. I've had to go through all 36 combinations a couple of times, though that's unlikely to be his problem. you can tell when the sequence is wrong because you get a click or jump from the motor when all the wires are connected properly. You also get a jump or click when you have a bad or no connection on a wire, so need to check that first.

For testing, disconnect the PAS and brakes to get it working with the throttle first. There's a setting to enable the throttle P4=0

 

[Nealh]

Just a thought as you have pas led lit, if you have brake sensor/s disconnect them and then try pas and throttle.