Hello I am Nick and I have a problem with my bike

[Baronburf]

I wonder if anyone can help me. I have a Correro crossfire E and if I don't ride it for a couple of days the moter doesn't work or only works intermittently. After using it for a while it works ok. Any ideas please

 

[vfr400]

Clean the contacts on the LCD.

If that doesn't do it, have a close look at the motor connector under the left side chainstay. it often gives problems. See if you can tie it with the two sides pushing together rather than tight pulling apart.

 

[Baronburf]

Clean the contacts on the LCD.

If that doesn't do it, have a close look at the motor connector under the left side chainstay. it often gives problems. See if you can tie it with the two sides pushing together rather than tight pulling apart.

Thanks for your reply.

 

[Baronburf]

Thanks for your reply.

There's no visible contacts/connectors under the LCD and the motor connector is okay

 

[Baronburf]

Clean the contacts on the LCD.

If that doesn't do it, have a close look at the motor connector under the left side chainstay. it often gives problems. See if you can tie it with the two sides pushing together rather than tight pulling apart.

Thanks for the suggestions. I have tried them but no luck

 

[vfr400]

In that case it's probably the torque sensor. All you can do is clean it. Unscrew it from the back of the chainwheel and clean out the very thin slots in it, which are optical sensors. if that doesn't work, try a new one.

SR Suntour Hesc Chain Set ATS Torque Sensor