Hailong Battery mount spare

[Peter.Bridge]

Hi all,

For my next project I was going to do another rear hub conversion of a Whyte Calendonian hybrid. I have already a mid drive 48v BBS02B conversion of my Boardman 29er.

I wanted to be able to swap the Hailong 48v 20ah battery (Samsung cells) between these two e-bikes depending on which one I was using

Is it possible to source another battery mount to be able to do this

 

[saneagle]

The answer is yes in theory, but there are several mounts for Hailong cases. The more common ones have blade connectors. I don't think I've seen your type on a separate mount, but I haven't specifically looked for it. If you have enough money, I think it would be a better Idea to buy a whole battery of the same type. Its better value overall. You get a spare battery in case of problems. You can go on very long journeys. Its more convenient. You'll need another battery sooner or later.

Those connectors are a bit more delicate than the blade type. Make sure that your battery is always switched off when you slide it in.

 

[Nealh]

The five pins round /bullet type bases can be found at TBK , you will have to check carefully to see if they are the exact same size for your battery.

Hailong 1 Battery Case Carrier (52 cells) [Hailong 1 Carrier] - $11.40 : Zen Cart!, The Art of E-commerce (topbikekit.com)

Hailong 1-2 Battery Case Carrier Hailong battery case carrier mounting without controller [Hailong 1-2 Battery Case Carrier] - $14.00 : Zen Cart!, The Art of E-commerce (topbikekit.com)

 

[Nealh]

If you are up for soldering and get the wrong base one could swap out and solder just the connector.

Hailong Battery Case Power 5pins discharge connector Male or Female [Hailong case 5pins connector] - $3.80 : Zen Cart!, The Art of E-commerce (topbikekit.com)

 

[Peter.Bridge]

Thanks @Nealh

I emailed tbk with pictures and the spec they identified it and gave me a link to their AliExpress site where the postage was much cheaper

Thanks again