Could someone who has used one of these glue guns, tell me if the glue can be softened and removed, by reheating the set glue with a heat gun or hair dryer.
I'm replacing one of my hall sensors attached to a tiny pbc inside the motor.
The pbc and sensors are currently held in place with a resin that can be heated and removed quite easily.
I need to be able to fix the pcb back in place securely, but not so much that it cannot be removed again, in case of another hall sensor failure.
I'm replacing one of my hall sensors attached to a tiny pbc inside the motor.
The pbc and sensors are currently held in place with a resin that can be heated and removed quite easily.
I need to be able to fix the pcb back in place securely, but not so much that it cannot be removed again, in case of another hall sensor failure.