The pedal sensor was damaged when the chain came off due to rider error. A wire was broken on the receiver (I hope that's the correct term).
I'm hopeless at anything practical so tried to find someone to repair it. None of those advertising ebike repairs would even look at it.
Found a guy who worked for Freego before they folded. He couldn't get it working.
The trike is now with a company who also can't get it working using the existing controller. They propose replacing the display, controller, battery ( the originals are in need of replacement ) & pedal sensor with the Provomec syatem that they are familiar with.
The Provomec controllers, https://www.promovec.com/en-us/components , show pedal sensor type as "speed". I remember reading on this forum that speed controllers are inferior to current controllers.
Ideally I would like to use KT dual voltage controller & use 48V batteries but need to find a company capable of doing the job.
I'm going to see the company who have the trike tomorrow afternoon.
Any advice please.
I'm hopeless at anything practical so tried to find someone to repair it. None of those advertising ebike repairs would even look at it.
Found a guy who worked for Freego before they folded. He couldn't get it working.
The trike is now with a company who also can't get it working using the existing controller. They propose replacing the display, controller, battery ( the originals are in need of replacement ) & pedal sensor with the Provomec syatem that they are familiar with.
The Provomec controllers, https://www.promovec.com/en-us/components , show pedal sensor type as "speed". I remember reading on this forum that speed controllers are inferior to current controllers.
Ideally I would like to use KT dual voltage controller & use 48V batteries but need to find a company capable of doing the job.
I'm going to see the company who have the trike tomorrow afternoon.
Any advice please.