Add Bafang throttle

[Rossco]

Hi all,

I have an Azor ebike that has a Bafang FM G311.250.V/D front wheel hub. It also has the basic display below.

零部件

Bafang description

bafang-e.com

I'm wondering how easy it would be to fit a throttle. I bought the throttle in the attached photo. I'm a novice so please forgive the nativity but I was hoping that I could just buy a Y splitter cable that could be connected to the existing display connection i.e so that thele display and throttle could both run off that - see attached photos. Unfortunately such a Y splitter does not seem to exist (it would need to have 2 green ends and one yellow). Any guidance much appreciated.

 

[Nealh]

The controller has to have the firmware to allow a throttle and a suitable compatible 3 pin connector, I assume the throttle is a Higo if a Bafang one.

 

[Rossco]

The controller has to have the firmware to allow a throttle and a suitable compatible 3 pin connector, I assume the throttle is a Higo if a Bafang one.

Thanks for the reply. The link to the throttle is below:

BAFANG Daumengas E-Bike PEDELEC Umbau Kit 3 Pin gelb female

Fahrrad E-Bike BAFANG BAFANG Daumengas E-Bike PEDELEC Umbau Kit 3 Pin gelb female

www.atmparts.eu

So basically the controller needs to have a throttle connection and also the firmware. It seems to be located under the bicycle rack at the back. Is it common for factory shipped bikes to have the required set-up do you know? As I mentioned,the bike was made by Azor (Dutch firm) so I could ask them. The alternative then I suppose would be to replace the connector which sounds like it's complicated

 

[Nealh]

I doubt the controller then is configured for one as they are illegal in the EU and they are stricter then the UK at policing.

 

[Rossco]

Thanks again, so i'd prob need to replace the controller then and to do that find someone with experience to do it. Any suggestions on what controller to get?