30A KT Sine Wave with KT-LCD8 LCD

[Adam Bodolai]

Hi Guys,
I hope you can help me with this problem. The situation is the following:
I go at a speed of 20km/hr then I stop pedalling (PAS) to lose speed and when I start pedalling again the motor immediately resistance/regen kicks in thus slowing down the momentum. It's like when you miss using the gear in the car and you use lower gear at high speed.

Im Using this controller:
bike Sensored Brushless Motor Controller 48V 1000/1500W 12-FET 30A KT Sine Wave with KT-LCD8 LCD Display Meter Panel for KT Series

Do you know any solution for this? I have tried many different value and setup,unfortunately, I have no clue why is this keep happening.

Any help is much appreciated.

 

[Nealh]

What battery are you using ?

C13 is regen set it to 0 and see if it helps.
P1 ?

 

[Adam Bodolai]

What battery are you using ?

C13 is regen set it to 0 and see if it helps.
P1 ?

Hi, Thank you for your help. The current setup is C13 is 0 and P1 is 100. I tried different as well without any success.

 

[Nealh]

Try P1 46 as this is the default setting for the heavy DD 1kw hubs.

If the P1 value is wrong I have found out speed and PAS sync on the motor pickup is affected.

 

[Adam Bodolai]

Try P1 46 as this is the default setting for the heavy DD 1kw hubs.

If the P1 value is wrong I have found out speed and PAS sync on the motor pickup is affected.

Thank you very much, I will check it out right away.