Search results

I will pull it apart over the weekend and take some snaps, however going off the amp meter from the display and putting a little amount of throttle on with power level set at 1 the amps don't reach anywhere near 10 under load, holding the bike from moving causes the jitter... although it powers...

I'm assuming the PAS is wired correctly as there's an led that lights up shown in pic... all cables are securely together, as for battery rating, the motor and battery are from a factory spec bike, the only change is the motor controller. battery rated just over 10 amps controller goes to 13amps

Update: So, the motor controller arrived, wasnt a brainpower model which wasnt a surprise... anyway the cables were pretty much the same as the BP, the system wouldnt work with pedal assist, but this could be down to the lack of hall sensors in the hub, So bought a thumb throttle and this got...

after doing some searching i found aliexpress are selling the boards required to adapt to standard hall sensors, found a 6 pin variant for my particular demand, and after seeing the part it made a bit more sense to me regarding how its powered and the signal lines, would really like to do...

Thanks for your reply, I have ordered it with the display, hopefully the 3 wires will suffice, either that or I'm stuck, and may have to strip down the hub and install a different hall unit

Looking to pick some brains here. Below is a pic of the wiring from the 250w hub motor, the standard 3 phase, but also 3 wires i assume is the hall (RED,WHITE,BLACK) i have a faulty motor controller so have decided to buy a replacement part from ebay, unfortunately i couldnt get a factory...