Search results

Not only very confusing but when I tested it for the very first time it grabbed me by the arm and threw me on the ground! and I was so pleased with my mod too! Another lesson learned

Exactly what happened, I had basically joined the two together, thanks

And somewhat ironically the throttle itself IS actually now sticking haha. Got a twist replacement here to try out so all good!

Yeah i didn't wanna confuse things more than I already had :) I thought the rear crank was interfering with it somehow at first but turned out to be irrelevant

The original chainring and pedal is one piece where the bafang requires the chainring and crank to he separate. I attached the original to the bafang chainring turning it into one piece again. It was purely a cosmetic mod to retain the 70s look of the bike but I can go without. Or I might...

Thanks dude, you're right that I did change something but ruled it out completely coz it doesn't really make sense, but it did make me go back step by step and seems ok now. Not understand it doesn't feel like a proper fix but all seems good now..I tried explaining it below..

Ok thanks guys for the help, especially vfr400 for pointing out that i must have changed something. I have found the problem even though it doesn't make sense to me. I adapted the original aluminum front cog to sit over the bafang cog to keep it looking original, it is just a facia with no...

Not tight at all. Cables are dangling until I fix the problem.

N No errors codes. Motor is normal (off)at power up, once throttle or pedals are activated it is on flat out.

no I put it in the new frame. It wasn't dropped or anything like that but i agree it does seem like a bit of a coincidence

I guess if I knew the cause I wouldn't be here asking but i think the spell seems the most likely. No bumps or drops, simply a changeover to another frame.

Motor starts as normal with throttle or by pedalling but goes straight to full power and won't stop until brake sensor activated or power disconnected. Acts more like a switch with no off. Yes problem persists with throttle cable disconnected. Was working fine in previous bike but problem...

Hi, I recently bought the 52v 1000w bafang motor. I had it briefly installed and running fine but now the throttle stays on and won't cut out when released. There is no throttle control, once it's on it stays on full. Same with pedal assist ..it will keep going until the ebrake sensor is...