Search results

Finding compatible Lishui controller /display isn't easy they are in the main OEM only , even if you found a lishui dipslay it may not work as they are I believe programmed to work as a pair . One reason why we mention recommend KT , they don't need to be programmed by a third party or a...

Cable ties are a cause of wireing issues , too tight and the pinch the wiring. One is better replacing all cable ties with velcro straps.

BBS01 has settings for that , check the 'time stop' & 'stop decay' values . Time stop setting approx. not less then 10 & stop decay one will have to play with to find what works. Time stop affects the drive stop once pedalling has ceased. Stop decay affects how much time the system takes to...

Nitrile then much better then latex.

Doesn't make sense or does decathlon warranty extend to 9 years ? I can't see decathlon giving you a new battery on a 9 year old bike going by the controller age/date ? At most I can see them maybe giving you a used second hand (maybe tired ) battery which is likely the cause or issue.

9 year old controller and a lishui system , tbh I would spend £80 and replace both controller and lcd with a KT. You would thank us later as you experience much better rider control and power use. What is the battery voltage hot off the charger and an hour or two later when rested ?

Tbh lion will keep to within 0.01v- 0.05v which is ore then adequate , they aren't so fussy like lipo . Most generic BMS are fine in lion and will happily look after the battery cells, every now and then ther eare failures but there are millions of these things in use so one has to expect a...

No . The ncm is likely a lishui or other brand, you will only see partial compatibililty . It will turn on and maybe show battery level but that is about it. If you want a KT display then you must marry it to a KT controller for 100% compatibility and vice versa.

House the controller in a bag , either a behind /under saddle bag or use top tube frame bag.

It is what we refer to as a KT 15a controller , other ampages are 17, 20, 22, 25 on so forth. 15a is a commonal defualt rating for KT if you buy other cheap china bikes the controller will be 12 or 13 sometimes.

Lipo have no BMS so need the balance wires for charging/balancing (unless like me and modded 8s and 4s lipo wiring for 12s and added a BMS , simply for the conveneance when charging ). Lion don't need balance wires as they don't go out of whack if normal and correct charging practices are...

Not an issue to add an exterior set of sense wires , though the jst will need protection from moisture . Easy for a home made diy pack (soft case ) contained with in a battery zip case but not so for a hard shell case where wirng and jst are out of view. For the most part balancing isn't needed...

Rear wheel is most often used , one can stack magnets if a gap is too large. I have double up a magnet before now to reduce the gap.

All will have a BMS incorporated.

Wisper bikes .

No issues with unpowered riding with both drives , tsdz2 is miles better then the bbs01 with no power .

Just pedal harder for more speed or buy a better drive type, my little G370 front hub easily gets to 22mph once I'm over the 15mph spd cut off. My tsdz2 also is easy to pedal to 20mph +.

Post the ad on Woosh used bike web page, it doesn't cost anything.

KT motor cut off is instant there is no over run. The main reason for fitting a brake sensor is to ensure one has a cut off so that one doesn't blow the controller when a throttle is fitted. Whether one uses the throttle matters not, the reason is in case of throttle failure/shorting via water...

Swap the motors over ?