Search results

Thank you for replying. anyone else out there, trek is a very popular bike brand.

I searched the internet but still cannot find a straight answer. I there a conversion kit to fit a mid motor to a trek with a bb95 bottom bracket? If so who produces them. Everywhere seem to go around the houses then talks about other types of bottom brackets. I’ve seen a couple of vids...

Mine is a barrel connector like the one in the pic, I believe it's five pin (need to check) however it's all irrelevant if I cannot find someone who has them to ask the the questions.

Looks like this is the one, would anyplace in uk stock it? http://shellmax.en.made-in-china.com/product/MotmNqOJkSVw/China-Electric-Vehicle-Parts-LED-Display-Power-and-Speed-6-1-Possition.html

my wife's French made easybike has a Chinese six speed display. Looks like most others with four buttons down the l/h side with power, speed, assistance setting etc. The four buttons are getting sticky very hard to work. Can I get a replacement and would a five speed work as most I've seen on...

Many many thanks to d8veh for help in sorting the bike out. It was the pas at fault...... And the 2nd one was too and that put me off course. The 3rd was tested by d8veh prior to me fitting and was of a different design (big orange block rather than a tube end). I was at my wits end when that...

That would be really really good of you, I can send the lcd, controller x 2 and the loom. I will put money in the package. Will you be emailing your address to me? Regards Dennis

If I could find your email I would have. What I was going to ask can you reccomended (or possibly sell me) a controller which does not require anything at the hub and a handlebar control to suit.

D8veh, any chance you could pm me? Ta

Then walk mode only works with the hall sensor pins in the position I wired them. If I try swopping the 5v and signal wire walk mode will not work. Today I refitted the original sensor that I thought was not working, it gives the same voltages as the new one. Does this mean the fault could be...

I will try that. In the mean time something for you...... If I press the two middle buttons together on the C300 LCD the motor runs without me having to turn the pedals even though it has a pas sensor on the crank? Pic of LCD in earlier mail above.

With the signal disconnected it remains 4.75 throughout wheel rotation. All of the plugs are unique and cannot be connected wrongly.

I was hoping to not have to dis-assemble the rear hub and de-solder again. I am happy not to have the speedo working. The controller must run sensor less as it did work with the plug undone prior to me trying to fix the speedo. Somehow connecting the speed sensor with the new hall changed...

It was replaced with a Honeywell SS41 as reccomended as a general use sensor for ebikes, no idea what original was. Not withstanding this the bike was working with the whole plug disconnected, now it isn't.

Thanks for getting back. Red and black 4.75v. Black and green 1.97v with a 2.12v pulse. Not counting the 3 thick wires there are 3 thin wires connected to a single sensor which is triggered by a magnet fixed to the inside of the hub cover.

Right folks, the story continues. I found that if I disconnected the hall sensor plug at the controller the bike would work. When I took the cover off the rear hub motor I expected to see 3 hall sensors however there was only one. I thought it must be a sensor for the speed display. I...

Thanks sacko however would prefer one I could buy in uk if possible.

Anyone know where I can get this model controller, possibly made by befang. Pic with details above.