Search results

hello, I installed s866, what you can adjust is when to run the engine, from 1/4 of a pedal stroke to 6-7 full turns of pedaling ... you can't adjust the intervention force of the motor ... if you plan to install s866 you must also change the original PAS with a magnet, the one installed does...

Let's stop for a moment and let's be clear, the 5 gear levels that I find when the controller is turned on work without problems (example gear 1 = 7km / h .. gear 2 = 12km / h ... etc ..) I'm talking to you about P12, changing the values of the P12 I have no difference or better not changing...

What you wrote is correct ... Pay attention to the arrangement of the wires in the plugs, check that the wires are in the correct position, that the red of the female plug is connected to the red of the male plug, etc...

ok, but the speed doesn't change either ... how do you explain it?

Hi, my model of the display is s866 while the controller is Brainpower Motor Controller KSLS58 ... Yesterday I did all the tests on P12 and it doesn't change anything, the initial force does not change and the initial settings do not change as vfr400 says ... P11 works very well (it works in...

I did the test you described to me .... it changes absolutely nothing ....

Hi, I checked does not go on standby after the set time ...

this is the extract of the instructions .... how do you translate the entry in P12?

The controller that I installed is s866 (250w).... Actually I can't find the difference in the 5 assistance powers (P12) While the start pedaling sensitivity works well (P11) .... I didn't try the switch-off time, today I try it then let me know ... As promised I set my parameters to have a...

Hi, my bicycle I have no problem of functioning, it works very well and I am satisfied. I have entered all the correct parameters (number of motor magnets, number of PAS magnets, diameter of circles ... etc.) but the speed shown on the display ( s866) was not correct (as in gps) so I changed...

ok! that's right, it's like I said ... so P7 = 20 not 1 ... while P13 = the number of magnets on the PAS disk .... thanks

why P07 = 1? shouldn't the number of motor magnets be set?

Thanks for your reply, I downloaded the manual but I would like to clarify ... The P7 item asks you to enter the number of motor magnets (da1a100), looking at the photos, posted by Alfred Kuhl, I counted 20, I ask confirm ... While item P13 asks you to enter the number of magnets on the PAS...

hello, I also have your bike, I installed your own control unit s866, but I don't know how to configure the item P7 which asks for the number of engine magnets, since you opened the engine you can tell me how many magnets it has? thank you. hallo, ich habe auch dein Fahrrad, ich habe eine...