I'll check the voltage but the display does turn on. What happens is that I get an error 10 code nor any speed readings. the original display wouldn't even turn on at all. It failed after 6 months of use. So the new one does turn on but receives no speed feedback and has the error code.
LCD S866 - not working - error E10?
- Thread starter crazymaster
- Start date
Hi. I tested the voltage and got 4.83 V so I don't know what else could be the issue. Ordered a new display with the 5s protocol and got the same error e10 code
Last edited:
I tried that but nothing happened so I am guessing it is an issue with the motor. They replaced a flat tire at a bike shop but I am not sure if they damaged the wiring.
There should be a connector on the cable about 10 inches from the motor. make sure that it's pushed all the way in, then a bit more. There's a line that shows how far in it has to go.
I tried to push it in as hard I could go but does the line need to touch the female connector edge?
That's a really good instructional photo, showing that it needs pushing in further, should bookmark for when people come here with problems
I tried pushing it in hard but I only hear like a click, not sure if I need to press it even harder with some pliers because it will not go all the way till the marker reaches the edge