Wayners's latest activity
-
Wayners replied to the thread Yose Power Hub- need a new rim!.Update. The woosh xf07 wheel fits and runs fine on standard yose controller however, the yose wheel comes with a long 9 pin cable and... -
Don't buy these cheap sh1te ones, they are very soft metal and I almost managed to rip a hose clip with two of these on a 1500W hub...
-
The critical measurement for a 26" wheel is the 559 (mm bead diameter) The choice of width depends on how wide a tyre you want to fit...
-
Wayners replied to the thread Yose Power Hub- need a new rim!.Here is a picture of my current rim with sizes. Any guidance on what rim is required would be appreciated. 26inch wheel. 599x19
-
-
Wayners replied to the thread E-bike or E-mtb. What am I not understanding?.I don't like fat tyres because of the road noise. Passed one yesterday the great lump. Seems some like that sort for reasons unknown...
-
Wayners replied to the thread HOW LONG WILL THIS RARE HUBLESS BIKE LAST? - PROPER DURABILITY TEST!.That's going to be a maintenance nightmare
-
Wayners replied to the thread Yose Power Hub- need a new rim!.Update. Ordered a new wheel from @Woosh.Andy was helpful. Should go straight on then I can repair the current yose wheel which will be a...
-
Wayners replied to the thread Yose Power Hub- need a new rim!.Yose 250w on a 26inch rim. I guess you need the technical measurements for the extract motor?
-
Wayners replied to the thread Yose Power Hub- need a new rim!.I need to fit a new rim to my front yose hub wheel. I unsure if it's something I can tackle or if I should just find a local shop to do...
-
Wayners replied to the thread 500 watt MOTORS A NO GO.Do we think 250w motors would be stamped 500w instead. Same motor
-
Wayners replied to the thread DFT consultation on increase of 250W limit to 500W.I never knew these existed.
-
Wayners replied to the thread Pas sensor question..Ok. I'll pick this up when I get that far. I've got frame. Forks. Front wheel. Derailleur. That's it so far. Waiting for better weather...
-
Wayners replied to the thread Pas sensor question..So its normal for left side. I think my current setup is left. I'm still building the bike. Was a second hand wisper step through frame...
