Bobbo1260's latest activity
-
Bobbo1260 replied to the thread Yosepower hub kits..The only problem we have is finding a uk supplier for a 15mm adaptor for the rear axle to fit the sprocket to. Seems you have to get... -
Bobbo1260 replied to the thread Yosepower hub kits..I made them myself from 1” steel conduit bent to shape using a pipe bender and welded at the bottom where I fitted a couple of 75mm...
-
Bobbo1260 replied to the thread Yosepower hub kits..With you guys seeming knowledgable about hubs and discs could you answer me this . My neighbour wants me to fabricate a bracket to...
-
Bobbo1260 replied to the thread Battery Fires.I wonder how many of these fires are down to sub standard replacement parts or the I’ll informed using higher capacity chargers to get a...
-
Bobbo1260 replied to the thread a question on walk mode.I use the walk button on my trike and don’t find it a big deal having to hold it down when pushing the trike as unlike a bike you have...
-
Bobbo1260 replied to the thread Slow pedal assist:.Well that must have been the cause of my problem as now the disc is running true and about 2mm from the sensor the motor kick in is...
-
Bobbo1260 replied to the thread Swapping wheel rims.Might give the re-lacing part a go myself as I have the rim and just need the spokes and get it trued up at a shop As suggested, thanks...
-
Bobbo1260 replied to the thread Slow pedal assist:.My electronics neighbour reconned my problem was with the distance too large between the two, the disc has to rotate faster to get the...
-
Bobbo1260 replied to the thread Low trike design advice needed.I’m basically removing the complete rear axle assembly and bolting a length of box section to it in place of the existing frame. The...
-
Bobbo1260 replied to the thread Slow pedal assist:.All I know is that now I’ve closed the gap between the sensor and crank shaft disc that contains the magnets the motor kicks in within...
-
Bobbo1260 replied to the thread Slow pedal assist:.Noting this post is a few years old if this helps anyone with a similar problem my Yosepower PAS wasn't kicking in unless I pedalled...
-
I have aquired a decentish bike for £20 thats in need of a paint job that i was told had 26" wheels but when i got it home i realised...
-
Bobbo1260 replied to the thread Low trike design advice needed.I did consider fitting smaller wheels as that would work with the pedals but the centre of gravity would only by lowered by 3 inches...
-
Bobbo1260 replied to the thread Low trike design advice needed.Hi Andy, You are spot on there . Even with some stabilisers I fitted trikes are still dodgy across unavoidable inclines, such as the...
-
-
Hi, Im new here and am hoping any bike/trike builders here can advise me. I am adapting my traditional upright trike with an e-bike kit...
