Hi all, I had a swytch system, I think is was iteration 2 , which I decided to replace with a bigger battery, KT controller, 12 magnet PAS, a twist throttle, and a KT5 lcd display. the only swytch part left is the 250W motor, with a nine pin connector. After assembling all the bits, and using the "walk" function to test the system, error three comes up , "motor hall signal abnormality" Any help would be much appreciated. Update, I heated the motoer cable connections, and the wheel functions on "walk mode", but does not turn when activated by the PAS. I ordered an 8 magnet PAS but received a 12 magnet unit. I'm going to remove half the magnets to see if this will work.
Rig the jig.
Rig the jig.
Last edited: