Hi, I am a new member on here but have had to call upon you guys to see if anybody else has suffered with the problems I have suffered.
The bike in question is a cube 140 hpa race with Bosch performance , intuvia and 400 watt battery.
The bike was purchased in May 2015 and within 3 months the battery failed and was replaced by the store.
At the end of November 2015 error code 500 ( internal sensor fault ) displayed on the screen. The bike was taken back to the dealer and 3 weeks later I got it back with a new motor from Bosch.
Last night whilst pushing my bike back into the garage the bike suddenly jolted forward and error code 500 was once again displayed. Error code 500 cuts all power to the motor.
This morning I switched back on and the error code had cleared, I rode around the garden and all was good ...phew !!! Then whilst on the bike stand in the garage the bike wheel suddenly started turning on its own accord then cut out.
This time error code 510 ( internal fault ) showed and all power was cut. I tried resetting the battery by holding down the power button on the battery for 20 secs, I reinstalled the battery , the display showed the speedo etc then the speedo went blank and the display shut its self down. Upon restarting the display no speedo is shown and all 5 of the green LEDs on the battery flash on and off once every 10 secs or so, the display shuts itself down.
This second battery is 6 months old, the second new motor is 11 weeks old and the bike is 9 months old.
I use the bike extensively and it is immaculately maintained regardless of cost, at this rate I will probably have 6 batteries and 6 motors before the warranty is up....losing the bike for 3weeksat at ago awaiting parts.
Your comments would be very welcome.
Ian
The bike in question is a cube 140 hpa race with Bosch performance , intuvia and 400 watt battery.
The bike was purchased in May 2015 and within 3 months the battery failed and was replaced by the store.
At the end of November 2015 error code 500 ( internal sensor fault ) displayed on the screen. The bike was taken back to the dealer and 3 weeks later I got it back with a new motor from Bosch.
Last night whilst pushing my bike back into the garage the bike suddenly jolted forward and error code 500 was once again displayed. Error code 500 cuts all power to the motor.
This morning I switched back on and the error code had cleared, I rode around the garden and all was good ...phew !!! Then whilst on the bike stand in the garage the bike wheel suddenly started turning on its own accord then cut out.
This time error code 510 ( internal fault ) showed and all power was cut. I tried resetting the battery by holding down the power button on the battery for 20 secs, I reinstalled the battery , the display showed the speedo etc then the speedo went blank and the display shut its self down. Upon restarting the display no speedo is shown and all 5 of the green LEDs on the battery flash on and off once every 10 secs or so, the display shuts itself down.
This second battery is 6 months old, the second new motor is 11 weeks old and the bike is 9 months old.
I use the bike extensively and it is immaculately maintained regardless of cost, at this rate I will probably have 6 batteries and 6 motors before the warranty is up....losing the bike for 3weeksat at ago awaiting parts.
Your comments would be very welcome.
Ian