bosco's latest activity
-
Bbosco replied to the thread Any ideas? Thanks in advance.I'll have to dig out the multimeter on Saturday. I want to buy a better ebike at somepoint, so I might as well learn on this one. Back...
-
Bbosco replied to the thread Any ideas? Thanks in advance.The bike is e+plus highwayman
-
Bbosco replied to the thread Any ideas? Thanks in advance.I get, getting the correct parts bit. But I still don't get what the test will tell me. Will it tell me that my controller is broken, or...
-
BMosfets have two modes of failure, they can go either open circuit or short circuit. A typical failure in a motor controller is a...
-
Bbosco replied to the thread Any ideas? Thanks in advance.Could I ask, what will the mosfet test tell me? Thanks.
-
Bike = bike. It would be useful if you can post a photo of the label on the controller. If you do decide to replace the controller it...
-
Bbosco replied to the thread Any ideas? Thanks in advance.What does ike stand for? Happy to give as much info as I can.
-
Bbosco replied to the thread Any ideas? Thanks in advance.I'll have to buy a new multimeter. I have one, but it's deep deep in the shed. Or I could get a mosfet tester?
-
BA controller mosfet test is carried out via the Phase wire bullet connections in your pic and doesn't need battery, It takes approx . 5...
-
Bbosco replied to the thread Any ideas? Thanks in advance.Can you explain what I'm doing with the multimeter? Everything is unplugged. I thought the error would be removed and identified if I...
-
Bbosco replied to the thread Any ideas? Thanks in advance.Can't I just replace the controller?
-
Bbosco replied to the thread Any ideas? Thanks in advance.Looked at all pins, look OK. Happy to keep diagnosing.
-
Bbosco replied to the thread Any ideas? Thanks in advance.I dont understand, if everything is plugged out how is there an error still unless is sits with the controller or the controller head?
-
BYes do check the Hall sensor block if it is the white 6 wire DJ7061, pins do a have a habit sometimes of backing out sometimes .
-
BHave you examined all of the connectors to make sure the pins are in good condition? I use a magnifying glass for this.
